Press Tonnage Calculator
Estimate the press force needed to blank and pierce a sheet metal part, and the press size to look for.
Results are estimates for planning. Confirm material properties with your supplier and final tool design with your toolmaker.
How the calculation works
The force needed to cut sheet metal is the length of all edges cut in one stroke, multiplied by the material thickness and its shear strength:
Cutting force (N) = cut length (mm) × thickness (mm) × shear strength (N/mm²). Divide by 9,810 to get tonnes.
The calculator adds the outer profile and every hole cut in the same stroke, then adds stripping force (the force to pull the punch back out of the material, typically 10–20% of the cutting force) and a safety margin, because presses should not run at their rated limit.
Using it for a progressive die
In a progressive die, every station works in the same stroke. Add the cut length of all stations into "Other cut length", and remember that forming and bending stations, spring pressure and pressure pads add further load not included here. Staggering punch lengths or spreading heavy cuts across stations reduces the peak force.
Typical shear strength values
The material list uses mid-range values. Shear strength varies with grade and temper, so use your material certificate where possible. If you only know tensile strength, shear strength is roughly 0.8 × tensile strength.
For a worked example and ways to reduce the force you need, read How to Calculate Press Tonnage for Blanking and Piercing. For the right tool steel for your punches, see D2 vs OHNS vs Carbide.
We design every progressive tool and press tool around the press it will run on. Send us your drawing and we will recommend the tooling and press size.
