Press Tool Maintenance Checklist: Daily, Regrind and Periodic Checks
Most die breakdowns give warning signs long before they stop the line: rising burrs, a misfeed now and then, a change in the sound of the press. A simple checklist, used every time, catches them early. Copy this into your own check sheet and adjust it to your tools.
Before every production run
- ☐ Tool number and part drawing revision match the job card
- ☐ Die set clean; no slugs, scrap or loose items on the die face
- ☐ Shut height set correctly for this tool
- ☐ Tool clamped squarely and securely
- ☐ Strip guides, pilots and lifters move freely
- ☐ Lubrication applied as specified for the material
- ☐ Misfeed and part-out sensors working (if fitted)
- ☐ First-off part checked against the drawing before running
During the run
- ☐ Burr height checked at set intervals
- ☐ Critical dimensions checked at set intervals
- ☐ Listen for changes in press sound; stop and inspect if it changes
- ☐ Slugs clearing properly; no slug pulling onto the die face
At each regrind
- ☐ Punches and dies reground to remove wear; record how much was removed
- ☐ Cutting clearance checked (see the die clearance calculator)
- ☐ Edges stoned to remove grinding burr
- ☐ Shims added if needed to restore punch and die heights
- ☐ Pilots checked for wear and diameter
- ☐ Springs checked for cracks and loss of force
- ☐ Stripper plate and guides checked for wear and alignment
- ☐ Trial strip run and first parts inspected before release
Periodically (for example every few regrinds)
- ☐ Guide pillars and bushes checked for wear and play
- ☐ Die set flatness and parallelism checked
- ☐ Fasteners and dowels checked for tightness
- ☐ Remaining grind life on punches and inserts reviewed; spares ordered in time
- ☐ Forming sections checked for wear and galling
What to record on the check sheet
| Field | Why it matters |
|---|---|
| Date and stroke count | Sets the regrind interval |
| Burr height before regrind | Shows how fast edges wear |
| Amount ground off | Tracks remaining life of each component |
| Components replaced | Shows which positions need spares |
| Problems seen | Reveals patterns: misfeeds, slug pulling, breakage |
Over a few months, these records show the right regrind interval for each tool. For high-precision jobs we regrind cutting elements about every 50,000 strokes, but the right figure depends on material, thickness and tolerance.
When the checklist finds a problem
Our guide to common progressive die problems covers the usual causes of misfeeds, slug pulling, burrs and punch breakage.
Need help? Our die maintenance and repair service covers regrinding, clearance correction and replacement punches and inserts cut on CNC wire cut EDM. Send us photos and a description of the problem.
