COST SAVING

How to Estimate the Cost of a Sheet Metal Stamped Part

November 03, 2026 · Atharva Engineers


Whether you are checking a supplier's quotation or budgeting a new part, it helps to know how the price of a stamped part is built up. Here is the method most buyers and suppliers use, step by step.

1. Material cost

Material is usually the largest share of the piece price for stamped parts.

Material cost per part = (pitch × strip width × thickness × density) × material rate

Use the strip area per part (pitch × strip width), not the part area, because the scrap skeleton is bought too. The strip layout calculation gives pitch and strip width. Steel density is about 7.85 g/cm³ (0.00000785 kg/mm³).

Some of the scrap can be sold back, which lowers the net material cost slightly.

2. Press (conversion) cost

Press cost per part = press hour rate ÷ parts per hour

Parts per hour depends on press speed (strokes per minute), parts per stroke and the uptime achieved. A progressive die producing one part every stroke at production speed makes this cost very small per part. A set of single-stage tools, where each part passes through several presses, multiplies it.

3. Tool cost (amortisation)

If the buyer pays for the tool separately, it is not in the piece price. If it is spread over the parts:

Tool cost per part = tool cost ÷ total parts expected over the tool's life or programme

This is why the type of tool matters: a costlier progressive die can still give a lower total cost at high volume. See what decides progressive die cost.

4. Secondary operations

Tapping, spot welding, assembly, deburring, heat treatment or inspection each add their own time and cost per part.

5. Finishing

Plating (zinc, tin, nickel), powder coating or painting is usually charged per part or per kg.

6. Packing, freight and overheads

Packing material, transport, inspection reports and the supplier's overheads and margin complete the price.

Worked example (illustrative figures only)

A 40 × 25 mm CRCA bracket, 1.2 mm thick, made on a progressive die:

  • Strip area per part: 27 × 44 = 1,188 mm²
  • Material volume: 1,188 × 1.2 = 1,425.6 mm³
  • Weight: 1,425.6 × 0.00000785 ≈ 0.0112 kg per part
  • At an illustrative ₹70 per kg, material ≈ ₹0.78 per part

The press, tool, finishing and freight are then added to this. Even small layout changes alter the first line: saving 2 mm of strip width here saves about 4.5% of the material cost on every part, for the life of the job.

How to get lower prices

The biggest savings are decided on the drawing, before the tool is built. See 5 ways to reduce sheet metal cost and the sheet metal design guidelines for stamping.

Want a real number for your part? Send us your drawing, material and annual volume. We reply within 24 hours with a technical review and a quotation for sheet metal stamping and tooling.

Free calculators: Press Tonnage Calculator Bend Allowance Calculator Die Clearance Calculator
Let's get started

Send Us Your Drawings

Get a technical evaluation and commercial quote within 24 hours.