TOOL DESIGN

Punch and Die Clearance: How Much, and Why It Matters

November 03, 2026 · Atharva Engineers


Cutting clearance, the gap between the punch and the die opening, is the single setting that most affects edge quality, burr height and how long a press tool lasts. Too tight and the tool wears fast and needs more force. Too loose and burrs grow and parts distort.

What clearance means

Clearance is usually given per side, as a percentage of material thickness (t).

Clearance per side (mm) = clearance % × t

So for 1.2 mm CRCA at 6% per side, the gap on each side is 0.072 mm, and the die opening is 0.144 mm larger than the punch overall.

Typical clearance by material

These are typical starting ranges per side. Toolmakers adjust them for part requirements, material temper and how long the tool must run.

Material Typical clearance per side (% of t)
Soft aluminium 4 – 6%
Copper and brass 4 – 6%
Mild steel / CRCA 5 – 8%
Stainless steel 7 – 10%
High-strength steel 8 – 12%

Starting values for planning only; final clearance is set during tool design and confirmed at trial.

Blanking vs piercing: which side gets the clearance?

  • Blanking (the part is the piece that falls through): the die is made to the part size, and the punch is made smaller by the clearance.
  • Piercing (the hole is what you keep): the punch is made to the hole size, and the die is made larger by the clearance.

Getting this the wrong way round makes every part undersize or every hole oversize.

How clearance affects the part

Clearance Edge and burr Tool life Force
Too tight Secondary shear, rough double edge, burr Shorter Higher
Correct Clean shear band, small burr Good Normal
Too loose Large rollover and burr, distortion Can cause slug pulling Lower

On electrical parts, burr height is often limited to about 10% of thickness. Our article on controlling burrs in high-speed stamping explains how clearance and regrind schedules keep burrs within that limit.

Keeping clearance correct over time

  • Even clearance all round matters as much as the value. Punches and die openings cut on CNC wire cut EDM from the same program hold an even gap.
  • Wear opens the clearance. Regrinding on schedule restores sharp edges; see common progressive die problems.
  • Alignment of guide pillars and bushes keeps the gap even under load.

Calculating press force for the same part? Use our free press tonnage calculator.

Burrs rising on an existing tool? Our die maintenance and repair service covers clearance correction and regrinding. For a new tool, send us your drawing.

Free calculators: Press Tonnage Calculator Bend Allowance Calculator Die Clearance Calculator
Let's get started

Send Us Your Drawings

Get a technical evaluation and commercial quote within 24 hours.