TOOL DESIGN

Types of Press Tools and Dies: Blanking, Piercing, Compound, Progressive & More

November 03, 2026 · Atharva Engineers


"Press tool", "press die" and "stamping die" all mean the same thing: a set of hardened punches and dies mounted in a die set, which cuts or forms sheet metal when a power press closes it. What changes between types is how many operations the tool does, and whether it does them in one station or several.

Single-operation tools

These do one job per stroke. They are simpler and cheaper, and suit low volumes or very large parts.

Blanking die

Cuts the outer profile of the part from the sheet. The piece that falls through the die is the part; the remaining skeleton is scrap. Used for washers, plates, brackets before forming, and laminations.

Piercing die

Punches holes, slots or windows into a part. Here the piece that falls through is scrap and the sheet with the hole is the part. Often used on blanks that were cut earlier.

Notching and parting tools

Cut away part of an edge (notching) or separate parts from a strip (parting / cut-off).

Bending and forming dies

Shape the metal without cutting: V-bends, U-bends, flanges, channels, embosses and ribs. Bending dies need to allow for springback, the small amount the metal returns after bending.

Drawing dies

Form cups and shells by drawing flat sheet into a cavity. Deep drawing needs special material grades and often several stages.

Multi-operation tools

Compound die

Cuts the outer profile and pierces holes in the same stroke at a single station. Because everything is cut at once, holes are very accurately positioned relative to the outline and parts come out very flat. Production is slower than a progressive die. See Progressive vs. Compound Dies.

Combination die

Combines a cutting operation and a forming operation (for example blanking and bending) in one stroke at one station.

Progressive die

The strip moves through several stations, and each stroke performs one stage of the part at every station at the same time. A finished part drops out at the end of every stroke, so output is very high. Progressive dies cost more to build but give the lowest piece cost at high volumes. See our progressive tool manufacturing service and how the strip layout is planned.

Transfer die

Separate stations like a progressive die, but the part is cut free early and moved between stations by fingers or a transfer system. Used for larger or deeper parts that cannot stay attached to a strip.

Which type is right?

Volume and part Usual choice
Prototype or a few hundred parts Single-operation tools or soft tooling
Moderate volume, flat and accurate parts Compound die
High volume, small to medium parts Progressive die
Large or deep parts at volume Transfer die

The decision also depends on tolerances, material and how much forming the part needs. Send us your drawing and annual volume and we will recommend the most economical tool, whether a press tool or compound die or a progressive die.

Sizing the press? Use our free press tonnage calculator and die clearance calculator.

Free calculators: Press Tonnage Calculator Bend Allowance Calculator Die Clearance Calculator
Let's get started

Send Us Your Drawings

Get a technical evaluation and commercial quote within 24 hours.