MATERIALS

CRCA, HR, GI or Stainless? Choosing Sheet Metal for Stamped Parts

October 21, 2026 · Atharva Engineers


Material choice affects piece cost, how the part forms, how it is finished and how long it lasts. For stamped steel components in India, four families cover most jobs. Here is how they compare.

CRCA (Cold Rolled Close Annealed)

CRCA is cold-rolled steel sheet that has been annealed for formability. It is the most common choice for precision stamped steel parts.

  • Thickness: commonly used from thin gauges up to around 3 mm
  • Finish: smooth, clean surface with tight thickness tolerance, good for painting or plating
  • Formability: good; deep-drawing grades are available for difficult forms
  • Typical parts: brackets, clips, enclosures, appliance and automotive components

HR / HRPO (Hot Rolled, and Hot Rolled Pickled & Oiled)

Hot-rolled sheet is produced at high temperature. HRPO has the mill scale removed by pickling and is oiled to slow rusting.

  • Thickness: usually thicker gauges than CRCA
  • Finish: rougher, with wider thickness tolerance
  • Cost: generally lower than CRCA for the same thickness
  • Typical parts: heavier brackets, structural and mounting plates where appearance is less critical

GI (Galvanised Iron)

GI is steel sheet coated with zinc for corrosion protection.

  • Strength: good corrosion resistance without separate plating
  • Watch out for: zinc can flake on severe bends, and cut edges are not coated, so edges can rust in harsh environments
  • Typical parts: electrical enclosures and boxes, ducting, mounting parts for outdoor or humid use

Stainless steel (SS 304, SS 430 and others)

  • SS 304: austenitic, excellent corrosion resistance, work-hardens quickly, so it needs more press force and wears tools faster
  • SS 430: ferritic, magnetic, lower cost, moderate corrosion resistance
  • Typical parts: food equipment, appliance parts, fasteners and clips that must not corrode

Stainless steel generally needs more press force and causes more tool wear than CRCA. Our press tonnage guide shows how much higher its shear strength is.

Quick comparison

Material Surface finish Corrosion resistance Relative cost Tool wear
CRCA Smooth Low (needs plating or paint) Medium Low
HR / HRPO Rough Low Lower Low
GI Coated Good (except cut edges) Medium Low to medium
SS 304 Smooth Excellent High High

Relative and general; actual properties depend on grade, temper and supplier.

Tips for buyers

  1. Specify the grade and thickness on the drawing, not just "MS sheet". Thickness should be in mm rather than gauge; see the SWG to mm chart.
  2. Use standard thicknesses where possible. Non-standard gauges add lead time, as explained in 5 ways to reduce sheet metal cost.
  3. Decide on finish early. Pre-coated sheet (GI) and post-plating (zinc on CRCA) behave differently in stamping and at cut edges.
  4. For electrical parts, copper alloys may be the better choice. See brass vs copper vs phosphor bronze.

We stamp parts in a range of steels on 10T to 60T power presses. Send us your drawing and we will confirm the material and suggest alternatives if they can lower your cost.

Free calculators: Press Tonnage Calculator Bend Allowance Calculator Die Clearance Calculator
Let's get started

Send Us Your Drawings

Get a technical evaluation and commercial quote within 24 hours.